Driver Side A/C Vent

This product is a 3D-printed driver/ corner vent for 1984-1989 1st Gen 4Runner or 1984-1988 2nd Gen Toyota Pickup. They are made using ABS plastic, the same material used in the OEM vents, but because they are brand new you don't have to worry about them cracking, disintegrating, or fading. These have also been reinforced in the weak spots we saw when modeling after the OEM vents. No metal clips are required to install this driver vent because we designed plastic clips into the model that will hold the vent in place.

If you have replaced your dash or are unsure if the dash in your truck is the original one from the factory, double-check which vent style is the correct one for your truck. There are two different versions of vent styles, the early model vent style ranges from model years (1984, 1985, 1986). This dash is known as the long pocket dash and as the name implies has a long pocket going from the middle vent to the passenger vent. If you have this dash style, make sure you choose (1984, 1985, 1986) as the model year even if your vehicle is a later model year. The late model vent style ranges from model years (1987, 1988, 1989) and this dash is known as the short pocket dash. This dash has a pocket over the 2 middle vents only. If you have this style of dash make sure you choose (1987, 1988, 1989) as the model year of vent style you need.

* If you have an aftermarket dash cap, it needs to be removed for proper installation*